Scooter Upgrade Kit Basic Edition

Is your scooter ready for an upgrade? Opt for a custom trick scooter featuring a threadless headset, a robust one-piece T-bar, a compression system, and two lightweight single clamps!

We've assembled a kit of five parts to enhance scooters with threaded headsets. This kit transforms your scooter from a threaded to a threadless model using ICS compression technology.
A trick scooter equipped with compression spins more smoothly and offers easier tightening, with a stronger one-piece bar.

This kit includes:
1x District Pro Threadless headset
2x District single clamp (32mm & 35mm)
1x Worx Royal Bar black one-piece T-bar (Alu. 35 mm outer)
1x Worx Royal pro scooter fork black threadless pro scooter fork
1x Worx compression kit.
Note: Grips are sold separately, but all grips are compatible with this bar.

Scooters eligible for kit upgrades:

• JD Bug Pro Scooter
• Razor Pro XX Scooter
• Razor Ultra Pro Lo Scooter
• Roces Kook Trick Scooter
• Slamm Rage Urban
• Grit Extremist Scooter
• Micro Bullet Street Pro 2.0 Scooter
• Grit Extremist Pro Scooter
• Madd Flow Scooter
• Micro Trixx scooter
• Razor Black Label 3.0 Scooter
• Razor Pro III Scooter
• Madd VX2 Pro 2012
• Razor Black Label 4.0 Scooter
• Madd VX2 Team Edition 2012
• Micro MX Park scooter

Also compatible with:

• Slamm Mischief
• K2 Park Pro Scooter
• Shaun White Trick scooter
• Grit Elite Scooter
• Micro MX Pro OPB Scooter
• District V4 Complete scooter
• Lucky Crew Scooter
• Madd MGP Ninja Scooter
• Madd MGP Ninja 2012 Scooter
• Madd Nitro End of Days 2012
• Madd Nitro Extreme Scooter

*Other scooters may be compatible for upgrades
*Handlegrips are not included, but you can reuse your existing ones or purchase a new set (all will fit).
*Tools required: Screwdriver, Hammer, Tape measure, Unbrako key, and a bit of mechanical skill ;)
-----------------------------------------------------------------------------------------------------------------------------------
Instructions:
Basic knowledge of trick scooter assembly is necessary. We advise consulting our guide before starting: read How to Assemble a Custom Scooter Here.
Upon receiving the kit, start by cleaning your existing scooter and removing the old headcups in the headtube.

1. Use a screwdriver to remove them and a hammer with a wood block in between to install the new ones to avoid damaging the deck or new headcups.
2. Insert the headset bearings into the new headcups.
3. Next, measure how far the new pro scooter fork reaches into the bar from the headset's top up to the starnut, which is already placed within the bar.
4. Ensure that the compression bolt can secure the starnut and streamline the entire system. If the starnut needs further adjustment within the bar, use a screwdriver to reposition it. Should it be positioned too high in the bar, there is a replacement starnut included for your convenience.
5. Finally, adjust the compression to your preferred spin.