The Stride kontrol adjusts the angle between the frame and the boot, deviating from the standard setup. This adjustment can enhance power transfer and allow for extended pushes.
Set includes 4 pieces at the same angle.
Crafted for use with Powerslide speed skates featuring a compatible frame.
James S.Yeading, United KingdomVerified Buyer5 of 5Excellent again BIG thanksRune SundlandOslo, NorwayVerified Buyer5 of 5Works as expected, easy to installS. StrandArendal, NorwayVerified Buyer4 of 5I have good experience with these. Works as intended.Kari NiemeläOulu, FinlandVerified Buyer1 of 5The material is too slippery. After only 5km of skating, the skate frames had already slipped laterally by several mm which eliminated the effect of the wedges and made the problem worse (with K2 MOD110).
Sandpaper foldable under one edge of the skate frame works better. It stays in place and the tilt can be fine-tuned by adding layers.Reply from SkateProSorry to hear that the material for the controls is too slippery! Unfortunately, this particular product is designed for Powerslide inline skates with a suitable frieze. This may explain why they did not fit your ice skates. Sorry about that :(
/Julia🛴Filippo VecchiottiWien, AustriaVerified Buyer5 of 5perfectMarcel GuldenaarTilburg, NetherlandsVerified Buyer5 of 5Super. Very satisfied.Aušra P.Brighton, United KingdomVerified Buyer5 of 5Good product. I had to cut off only two pins from each item to make it fit the FR frame/boot. The pronation of the foot improved. Make sure not to cut all four of them, as it may slide off from under the frame.M. ClaverMalden, NetherlandsVerified Buyer5 of 5Very nice solution to get right on the speed skates.Allan Bjarnø JensenKarlslunde, DenmarkVerified Buyer5 of 5Works really well.Victor JohansenRoskilde, Denmark5 of 5God damn... It seriously helps SO much with my knee pain with stride control... There were some with my swell ice skates that I have been using... It's awesome... Love powerslide so much.
NOTE: Be aware that if you have problems with pain on the inside of your knee because your knee is tilted inwards, the high part of the stride control should be on the outside... It seems a bit strange. But it's good enough.
